## Power Mechanics Paper 2 Questions and Answers - Bunamfan Cluster Pre Mock Exam 2022

Instructions To Candidates

• All the questions have equal marks.
• Do not spend more than 15 marks per station.
• Once you leave a station, you will not be allowed back to the same station.

## Questions

STATION 1
INSTRUCTIONS
Draw an assembled valve train system. (10mks)

STATION 2
INSTRUCTIONS
Using the tools, equipment and materials provided, make the handle as shown in the figure below. (10mks)

STATION 3
INSTRUCTIONS
Identify the items labeled A to E. State the material each is made of and one use of each part in a motor vehicle (10mks)

 ITEMS MATERIAL USE A B C D E

STATION 4
INSTRUCTIONS
Provided on the bench are hand tools used in mechanics. Study them and fill the table below appropriately. (10mks)

 TOOL NAME USE A B C D E F G H I J

STATION 5
INSTRUCTIONS

• Using tols and gear oil pump provided, carrry out the following tasks;
• Dismantle the pump
• Perform neccessary service checks
• Assemble the pump (10mks)
• Let the examiner check your work

STATION 6
INSTRUCTIONS
Identify the motor vehicle parts labelled J, K, L, M and N. Name each part, state the vehicle system it belongs to and state its main function in a motor vehicle. (10marks)

 PART NAME VEHICLE SYSTEM FUNCTION J K L M N

STATION 7
INSTRUCTIONS
On the single engine provided;

1. Remove the exhaust valve.
2. Measure and record the exhaust valve diameter.
3. Name the tool you have used to take the reading.
4. Assemble back the engine.

Let the examiner check your work. (10mks)

STATION 8
INSTRUCTIONS
Study the welding equipment provided. Name and state the function of the parts labeled. (10mks)

 PART NAME FUNCTION P Q R S T

STATION 9
INSTRUCTIONS

1. Take the following measurements of the marked parts of the camshaft provided. (7mks)
1. Camlobe height using vernier calipers.
2. Camlobe diameter using micrometer provided
3. Journal ovality using dial indicator.
2. State the accuracy of each of the following tools. (3mks)
1. Vernier calipers
2. Micrometer
3. Dial indicator

STATION 10
INSTRUCTIONS
Connect correctly the battery ignition circuit, using the components of the ignition system laid on the bench. (10mks)
Let the examiner check your work.

• ✔ To read offline at any time.
• ✔ To Print at your convenience
• ✔ Share Easily with Friends / Students