INSTRUCTIONS TO CANDIDATE:
- Write your name, AdmNo, and Stream in the spaces provided.
You should have the following for this examination; - Drawing instruments
- Scale rule
- 3 sheets drawing papers size A3.
- This paper consists of ONE compulsory question.
- This paper is to be issued to the candidates 30 minutes before the examination starts
- The candidate is advised to spend this time understanding the design problem and planning the work on one of the drawing papers provided.
- Candidates may be penalized for not following the instructions given in this paper.
DESIGN PROBLEM (40 MARKS)
Design a coffee table for two which can also serve as a drawing board.
Consideration
- It should be stored in a vertical position when not in use.
- It should be able to serve people of various heights.
- It should be comfortably used as a drawing board without much straining.
Requirements
- Sketch two possible solutions. (6mks)
- Draw a fully labeled pictorial drawing of the selected solution. (11mks)
- Draw exploded drawing to allow for;
- Consideration 1. (5mks)
- Consideration 2. (5mks)
- Consideration 3. (5mks)
- State three types of materials used and where applied. (6mks)
- State two methods used in joining the parts and state where each joint is applied.
MARKING SCHEME
- TWO POSSIBLE SOLUTION
- 2 functional sketches award 3 marks each max 6 marks
- 1 functional sketch award 1.
- LABELLED PICTORIAL SKETCH 11Marks.
- Good looking sketch meeting the three considerations (collapsibility, height adjustment and angle adjustment) award 4 marks
- Proportionality. (2mks)
- Correct projection (Isometric, oblique, perspective). (2mks)
- Line work. (2mks)
- Accuracy (1mk)
- EXPLODED SKETCH OF MECHANISMS
Consideration 1 collapsibility
Functional sketch. (3mks)
Line work (1mk)
Neatness (1mk)
Consideration 2 height adjustment
Function sketch (3mks)
Line work.(1mk)
Neatness
Consideration 3 angle adjustment
Functional sketch (3mks)
Line work (1mk)
Neatness (1mk) - THREE MATERIAL USED AND WHERE APPLIED
- Wood (be specific i.e. hard /soft, ply block board) for the top. (2mks)
- Metal (be specific i.e. tubular bars or round bars) for stands (2mks)
- JOINING METHODS award 1 mark for max.2 marks
- Bolts and nuts –stands
- Screws block board to metal
- Gluing -rubber to metal
Download Drawing and Design Paper 2 Questions and Answers - Samia Joint Mock Examination 2021/2022.
Tap Here to Download for 50/-
Get on WhatsApp for 50/-
Why download?
- ✔ To read offline at any time.
- ✔ To Print at your convenience
- ✔ Share Easily with Friends / Students